[. . . ] There should be at least 2 inches (5 cm) of clear space on all sides of the switch. 100 Mbps Depending on the speed of your network devices, you need a Category 3 (10 Mbps), Category 5 (100 Mbps) or Category 5e (1000 Mbps) Ethernet cable with RJ45 connectors for each device you want to connect to the switch. [. . . ] If the socket is controlled by a light switch, make sure that the switch is in the on position. Make sure you that are using the NETGEAR power adapter supplied with your switch. The Port number light is not lit for a connected device or stays on continuously. €¢ • • • Make sure that the cable connectors are securely plugged in at the switch and the device. If the Ethernet cable is connected to a NIC or other Ethernet adapter, make sure that the card or adapter is installed correctly and is working. Prepare to Install the Switch Decide where you want to place the switch. You can use wall-mounting screws (not provided) to hang the switch in an open space on a wall. Make sure the selected location is: • Not in direct sunlight or near a heater or heating vent. Connect the power adapter cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip). After completing the installation, locate the serial number on the bottom label of your product, and use it to register your product at: http://www. Registration on the website or over the phone is required before you can use our telephone support service. The phone numbers for worldwide regional customer support centers are on the Warranty and Support Information card that came with your product. [. . . ] NETGEAR and the NETGEAR logo are registered trademarks of NETGEAR, Inc. Other brand and product names are trademarks or registered trademarks of their respective holders. [. . . ]